Mtw Series European Trapezium Grinding Works

[Zenither6]

The series mill machine work process following: big block material by jaw type broken machine broken to by needed grain degrees hou, by upgrade machine will material sent to storage hopper, again by vibration to material machine will material uniform quantitative continuous to into host mill indoor for grinding, powder mill hou of powder child with wind machine air rose, by selected powder machine for grading, meet fine degrees of powder child with air by pipeline into big cyclone collection device within, for separation collection, by out powder valve discharge that for finished powder child. air return air duct at the top by the cyclone dust collector suction centrifugal fan, the entire air system is a closed loop, and is in a state of positive and negative pressure circulates.
Dang to get more fine grain degrees powder when, on must improve leaves speed, makes leaves and powder child contact increased, makes not requirements of powder child was leaves throwing to outside wall and air from, rough powder child for itself gravity of portable crusher role fall into mill room for heavy mill, qualified of finished powder child through leaves with air inhalation big cyclone set powder device within, air and powder child was separation hou, powder child was collection.
In mill indoor for was mill material in the has must of moisture, grinding shi produced heat led to mill indoor gas evaporation change has gas flow, and machine the pipeline joint at sealed vertical roller mill not strict, outside gas was inhalation, makes cycle air air increased, for through adjustment wind machine and host between of exhaust tube to reached air of balance, and will extra of gas import bag dust collector within, put more than gas with into of powder child collection up, more than gas was purifi SBM ion hou discharge. host process is through the driven bevel gear integral transmission center shaft, the upper end of the shaft coupling roller hangers, rack is equipped with roller unit and formed the swing pivot. roller device not only rotating around the center axis and revolution around the ring, rotation due to friction the roller itself. roller hanger under the blade, its lo SBM ion in roller bottom blade and roller with toss items in the process of feeding between grinding roll and ring, forming mat layer, the layers by roller rotates outward centrifugal force (pressure) to crush items, and thus achieve the purpose milling. separator by variable speed motor drives the blades rotating on a turntable, the formation of the powder grade. blade speed speed is adjusted according to the grain size of powder.
Cyclone powder-mill performance played an important role when the powder into the collector, is rotated at high speed, air flow and powder separation, gas wall sand making machine to the center until the end of cone when (flow length) form an upward airflow spin round, powder falls is collected.