26.10.2017, 03:38
Yipengjack Car Transmission Jack is placed inside the car's toolbox and is used to lift the body when replacing spare tires. How is the speed of the car transmission jack to adjust? Today we will discuss this issue. In the process of using the car jack, its speed is often required to be adjusted. Automobile jack speed adjustment of the attention can be caused by the following aspects of heavy.
We need to adjust the speed of the car transmission jack at the same time also need to adjust the position of the car jack jack up part, so as not to make the transmission parts too tight or stuck phenomenon. If the car jack mixed with air, the speed will be unstable, therefore, in the debugging process need to open the exhaust jack of the car jack, remove the air stranded in the jack.
In addition, before adjusting the speed of the car transmission jack, but also need to load the current speed once, to exclude the car jack cavity air, in the debugging process should also adjust the buffer device, until the stability of the jack to meet the requirements of the jack. If the car jack buffer device is not adjustable, you must remove the car jack, commissioning in the test bench after the commissioning of qualified equipment.
Automobile Floor Jack Low Profile speed debugging should be in the jack normal oil pressure and normal oil temperature operation, the speed stability of the hydraulic system requires a high degree of observation of its speed changes. After the speed of debugging, you need to adjust the car jack stroke position, program action and safety interlock device. Until the indicators have reached the design requirements, to be able to run. The above is to adjust the jack speed of the note.
We need to adjust the speed of the car transmission jack at the same time also need to adjust the position of the car jack jack up part, so as not to make the transmission parts too tight or stuck phenomenon. If the car jack mixed with air, the speed will be unstable, therefore, in the debugging process need to open the exhaust jack of the car jack, remove the air stranded in the jack.
In addition, before adjusting the speed of the car transmission jack, but also need to load the current speed once, to exclude the car jack cavity air, in the debugging process should also adjust the buffer device, until the stability of the jack to meet the requirements of the jack. If the car jack buffer device is not adjustable, you must remove the car jack, commissioning in the test bench after the commissioning of qualified equipment.
Automobile Floor Jack Low Profile speed debugging should be in the jack normal oil pressure and normal oil temperature operation, the speed stability of the hydraulic system requires a high degree of observation of its speed changes. After the speed of debugging, you need to adjust the car jack stroke position, program action and safety interlock device. Until the indicators have reached the design requirements, to be able to run. The above is to adjust the jack speed of the note.